Download Buffalo TS5810DN NAS Firmware 5.46 Free

Added and modified features:

– [Secure Erase]: It is now possible to use the Secure Erase feature to remove all data from the drive in a way that is nearly impossible to recover with current tools.
– [Dropbox Sync]: Modified to add the Status field of the job.
– [Migration]: Modified to add an option to change the processing speed during migration of data or settings from SMB-compatible NAS devices.

Bug fixes:

– [Users]: Fixed a bug where the admin password could not be changed if the primary group was changed.
– [iSCSI]: Fixed a bug where ISCSI volumes could not be mounted as a datastore cluster from VMWare ESXi.
– [Configuration Migration]: Fixed a bug where shared folders could not be restored.
– [Remote Management Service]: Fixed the problem that the abnormal shutdown event did not disappear after the TeraStation was forcibly shut down.
– [Settings]: Fixed a bug that the settings could not be accessed after restoring the settings.
– [Settings]: Fixed bug where settings could not be used due to persistent session timeout.
– [System]: Fixed a bug where the shutdown process would take a long time if the TeraStation could not communicate with the domain controller while configuring the AD domain.

warn:

– If you experience any issues with this firmware update, please consult your local technical support representative.
– Do not turn off the device until the update is complete. This will take a few minutes. You will receive a message when the update is complete.
– The USB drive is not automatically mounted after a firmware update. To install them, unplug and reconnect.

How to use the updater:

1. Connect the TeraStation properly and configure the TeraStation and computer to run the updater on the same network subnet. The subnet masks should be the same, and the first three digits of the IP addresses should be the same. The last digit of the IP address should be different.
For example, if the computer’s IP address and subnet mask are
“192.168.0.10, 255.255.255.0”
The TeraStation’s IP address and subnet mask are
“192.168.1.150, 255.255.255.0”
then the updater will _not_ work properly.
In this case, reconfigure the TeraStation’s IP address and subnet mask to
“192.168.0.150, 255.255.255.0”.
Then they will be on the same subnet and the updater will work fine.
2. Close all applications. Also, stop or exit any firewall software.
3. Unzip the downloaded file and run “TSUpdater.exe”. When a TeraStation is detected, an update window will open.
4. If multiple TeraStations are connected, select the TeraStation to update.
5. Click Update and enter the TeraStation’s administrator password.
6. Click OK.
7. The transfer and update firmware will start. Wait until it’s done. The information LED will blink during the update.
8. When the update is complete, a message will be displayed.

Regarding NAS updates:

Upgrading Network Attached Storage (NAS) firmware can improve the overall performance, stability, and security of your system by adding various fixes for related issues, enhancing existing features (or adding support for new features), or updating different applications.

With so many NAS manufacturers and types of network storage, installing new firmware may not always be as easy as it seems — and not very secure either. Failure to perform a software update could result in a critical failure of the NAS.

Therefore, before you consider applying this release, please read the installation guide carefully and start the process only after you understand and are fully familiar with all the steps.

Also, it is best to consider using a UPS unit (Uninterruptible Power Supply) for this task, as a power outage will not affect the upgrade.

With all these aspects in mind, after reading the installation guide, click the download button to apply this firmware version to your NAS. Remember to check our website to stay up to date with the latest releases.