Download Buffalo TS5810DN NAS Firmware 5.00 Free

Download Buffalo TS5810DN NAS Firmware 5.00 Free

Download Free Buffalo TS5810DN NAS Firmware 5.00

Added and modified functions:

-Dropbox sync: Modified to support API updates provided by Dropbox.
-Dropbox Sync: After modification, shared folders with multi-byte characters in their names can no longer be used on TeraStation. For customers who have configured their folders on TeraStation to contain multi-byte characters in their names, please delete the Dropbox sync job and reconfigure the folders to use only single-byte characters.
-Dropbox Sync: Modified the previous process that occurred before the start of the sync process. This process will increase CPU usage. To reduce it, change the synchronization interval from the default 5 minutes to a longer duration.

warn:

-If you encounter any problems caused by this firmware update, please consult your local technical support representative.
-Do not turn off the device before the update is complete. This will take a few minutes. After the update is complete, you will receive a message.
-The USB drive will not be installed automatically after the firmware is updated. To install them, unplug and reconnect.

How to use the update program:

1. Connect the TeraStation correctly and configure the TeraStation and the computer to run the update program on the same network subnet. The subnet mask should be the same, and the first three digits of the IP address should be the same. The last number of the IP address should be different.
For example, if the computer’s IP address and subnet mask are
“192.168.0.10, 255.255.255.0”
The IP address and subnet mask of the TeraStation are
“192.168.1.150, 255.255.255.0”
Then the update program will _not_ work properly.
In this case, reconfigure the IP address and subnet mask of TeraStation to
“192.168.0.150, 255.255.255.0”.
Then they will be in the same subnet and the update procedure will work normally.
2. Close all applications. In addition, stop or exit any firewall software.
3. Unzip the downloaded file and run “TSUpdater.exe”. When TeraStation is detected, an update window will open.
4. If multiple TeraStations are connected, select the TeraStation to be updated.
5. Click “Update” and enter TeraStation’s administrator password.
6. Click OK.
7. The firmware transfer and update will begin. Wait until it is finished. The information LED will flash during the update.
8. When the update is complete, a message will be displayed.

About network attached storage update:

Upgrading the network attached storage (NAS) firmware can improve the overall performance, stability and security of the system by adding various fixes for related issues, enhancing existing functions (or adding support for new functions), or updating different applications.

Due to the large number of NAS manufacturers and the large number of types of network storage, installing new firmware may not always be as easy as it seems-and it is not very secure. Failure to perform a software update may cause serious failure of the network storage.

Therefore, before you even consider applying this version, please read the installation guide carefully and start the process only after you understand and are fully familiar with all the steps.

In addition, it is best to consider using a UPS device (uninterruptible power supply) to perform this task, because a power interruption will not affect the upgrade.

Considering all these aspects, after you read the installation guide, click the download button to apply this firmware version to your NAS. Please remember to check our website to keep up to date with the latest version.

It is strongly recommended to always use the latest driver version available.

Try to set the system restore point before installing the device driver. This will help if you have installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or no longer supported.